How can I enable Drop Zones in Workshop?

Ask the Community
1

Hi there,

The Workshop doc mentions the use of drop zones here: https://www.palantir.com/docs/foundry/workshop/drag-and-drop#workshop-drop-zones

and in particular, it tells you that if it is not enabled, you should reach out to the platform admin (which is myself). I’ve been looking around in control panel to enable this feature, but so far no luck. AIP tells me the following:

As an admin, Drop Handling in Workshop is typically enabled per section by toggling the “Drop Handling” option in the section configuration panel. If you or your users do not see this toggle, it may be due to a platform-level restriction or feature flag that is not exposed in the standard admin UI. In this case, you should contact your Palantir support representative to request that Drop Handling be enabled platform-wide for your environment. There is no documented setting in the Control Panel or Workshop admin tabs to enable this feature globally for all users

Is this actually a platform wide config that Palantir has to enable for my environment ?

Thanks !

Morgan

2

I think this might be a dev tier thing. Tested it on my end (also on dev tier) and ran into the same issue.

3

I’m on a PFB stack, not a dev tier. I’ll reach out to support next week, seems like they might have to manually enable the feature.